Skip to content
Padhora
Sign in
BrowsePlans

DI04019041 · Semester 4 · 5G scheme

Fabrication Technology

Notes and solutions following the Gujarat Technological University (GTU) syllabus for DI04019041. Independent material — not issued by the university.

Mechanical Engineering

Materials

Syllabus

The official syllabus this material follows.

  • Syllabus

    13 pages

    FreeRead

Complete Book

The whole syllabus, unit by unit, written for the exam.

Slides

Lecture slides for revision.

Syllabus units

Unit 1: Introduction
  • 1.1 Term fabrication
  • 1.2 Need and scope of Fabrication technology
  • 1.3 Weldability of materials
  • 1.4 Term manufacturing and fabrication
  • 1.5 List different code & standards (with full forms) used in fabrication & erection of equipment / piping.
  • 1.6 Major national and international fabrication companies
  • 1.7 Major national and international third party inspection agencies
  • 1.8 General Designation used for various engineering items.
Unit 2: Drawing Interpretation
  • 2.1 Drawings
  • 2.2 Fabrication documentation preparation from drawing
  • 2.3 Raw material requirement calculation from drawing
  • 2.4 Welding detailing preparation from drawing
  • 2.5 Introduction to Code and standards used for fabrication
Unit 3: Fabrication Processes
  • 3.1 Welding Process requirements
  • 3.2 Fabrication procedures
  • 3.3 Fabrication steps for with equipment function, name of parts
  • 3.4 Safety norms for
Unit 4: Inspection and Testing
  • 4.1 General terms regarding weld quality
  • 4.2 Destructive Testing (procedure as per ASTM / ASME sec. v and Acceptance criteria as per ASME sec. viii div.1)
  • 4.3 Non Destructive Testing (procedure as per ASTM / ASME sec. v and Acceptance criteria as per ASME sec. viii div.1)
  • 4.4 Special type of testing for equipment / piping operation
  • 4.5 Running inspection methods, visual inspection
Unit 5: Surface preparation, Finishing and Coating Methods
  • 5.1 Surface preparation methods
  • 5.2 surface finishing methods
  • 5.3 surface color coating methods
  • 5.4 coating film thickness measurement techniques
Unit 6: Installation, erection and commissioning of process equipment
  • 6.1 Term installation, erection and commissioning
  • 6.2 Difference between installation and erection
  • 6.3 Type of static process plant equipment vessels, heat exchangers, distillation columns, piping & valves etc.
  • 6.4 Type of rotary process plant equipment pump, fan, blowers, compressors, agitators, filters, turbines etc.
  • 6.5 Installation of centrifugal pump at site
  • 6.6 Erection of vessel at site
  • 6.7 Erection and mechanical clearance of piping spools at site
  • 6.8 Commissioning of process plant

About this course

Study materials, question papers, and solutions for Fabrication Technology (DI04019041) - Mechanical Engineering, Semester 4